Hello,
I have a Powerpoint CH581 extractor hood in the kitchen that works fine on all 3 speed settings but no longer lights the 4x12v halogen lights, I pulled out the pcb and found some parts of the board that had alot of heat but nothing I can see is fryed. There is a fuse resistor that I removed and tested, and it is fine. The nearest transformer to the light connector (connected with copper trace on the rear)has a split in the wraping, could this be the problem?
I have a Powerpoint CH581 extractor hood in the kitchen that works fine on all 3 speed settings but no longer lights the 4x12v halogen lights, I pulled out the pcb and found some parts of the board that had alot of heat but nothing I can see is fryed. There is a fuse resistor that I removed and tested, and it is fine. The nearest transformer to the light connector (connected with copper trace on the rear)has a split in the wraping, could this be the problem?
Comment