Thank you to the guys at HEGE supporting Badcaps [ HEGE ] [ HEGE DEX Chart ]

Announcement

Collapse
No announcement yet.

Help me identify this capacito/resistor

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    #21
    Re: Help me identify this capacito/resistor

    I am assuming these are resistors based on my studies of the datasheet. I know MC301 is not the same as MC201 but the look very similar. I am gambling here by reading the values on MC201 and hoping i can put those on MC301. Reading the same resistors on MC201 that i didn't mess up. One reads 9.5 KOhms and the other reads 1.0 Kohms. The package size is 0402 or 1005 metric. I am unsure about the Voltage though. The board is supplied with 15V so do i just need to make sure these resistors are rated for at least 15V or does it need to be rated at 15V?
    Thanks!

    Comment


      #22
      Re: Help me identify this capacito/resistor

      Any ideas? Anyone?

      Comment


        #23
        Re: Help me identify this capacito/resistor

        Hmm-- a 15V Resistor....

        Resistors rated for a voltage....?

        These aint for leakdown or EHT, Any cruddy thing the right size and value will work--Its a Resistor!!
        TELEFIX

        How PLASMA SCREENS WORK, X-SUS and Y-SUS what they do--
        http://www.irf.com/technical-info/appnotes/an-1088.pdf
        PLEASE DO NOT EMAIL ME PRIVATELY FOR REPAIR ADVICE. QUESTIONS BELONG ON THE FORUM!

        Comment


          #24
          Re: Help me identify this capacito/resistor

          Well I replaced all as planned and now i get a one blink code and screen doesn't turn on?

          Comment


            #25
            Re: Help me identify this capacito/resistor

            1 blink if i remember is STV 5v sense DG Board

            Comment


              #26
              Re: Help me identify this capacito/resistor

              All i found was it was communication error with microprocessor? The service manual doesnt give any diagnostic advice. Any one got any ideas?

              Comment


                #27
                Re: Help me identify this capacito/resistor

                i have just saw this video too regarding 1 blink being a bad mainboard
                https://www.youtube.com/watch?v=HUxD72qoays
                tom66 says in this post it may also mean a general error
                https://www.badcaps.net/forum/showthread.php?t=25026
                Last edited by vinceroger69; 08-19-2016, 02:56 AM.

                Comment


                  #28
                  Re: Help me identify this capacito/resistor

                  Found last night i forgot to plug in one connector. Turned on and worked good for about 3-4 mins then blew F301 and the heat sink on Q301 Q201 was extremely hot. now im back to 10 blink where i started. whats causing this? I started another thread as we are getting a little of topic of the title of this post

                  Comment

                  Working...
                  X