Need master bios unlock code

[theguyed]

Service Tag GCL08C3

Master Bios Code GCL08C3-8FC8

Any one have the unlock code...

[TRCFL]

Would someone be willing to share a schematic & board view for a Lenovo L13 Gen 2 - Type 20VJ?
Thanks!!

[Dileesh]

Hi, Anyone happens to have boardview for Asus TUF Gaming Z690 D4?

[iTec]

Hello everyone, I'm not really sure if this is the right place to actually post about this, but i have Aiper Scuba X1 that I'm trying to read the Microcontroller data from. The chip is National N32G455. After dismantling the unit I found a Debug connector and on the backside of the board 6 point that reads: GND RX VCC SWD TX SWC. I'm familiar with Nuvotons, MECxxx, ITE chips but NOT these kinds of microcontrollers. I need someone who can direct me to what's needed to read it ONLINE as they have coated the entire board. I got the ST-Link yesterday and connected the wires as shown in the picture...

[Harryrepair]

Hello community,

i bought myself this nice laptop for repair training.

MSI Cyborg 15 A13V (Boardnumber MS-15K11)

It can be charged and powered on. It stays for 20 seconds without showing any picture, even no BIOS.
All MAIN Power rails are present, CPU with 0.8V. USB Ports with 5V.
Shuts down after 20 seconds.
RTL8111H seems warm with about 34degrees celsius.

Someone mentioned to check PLTRST# , but there is no schematics available.

Could you assist me with any hint?...

[dr.thodt]

Hi,

I have an HP 15-ec2531nd here which does the following:
- Turns on. One of both fans goes full throttle. Other doesn't spin up.
- BIOS works.
- All self tests pass, except smart pin. Not even with another adapter connected.
- RAM is ok.
- RAM slot pins are ok.
- Battery is ok.

Whenever I want to boot Windows from m2 SSD system switches off.
I have a USB stick with several tools on it, including Windows PE. I can browse this stick's menu, but when I start Windows PE, the laptop switches off at the same point where it would...

[keysersoze2019]

hi guys

i've got a lenovo m920s 10sk s28m00 with a supervisor password set in bios

s/n: s4kg1433

i've tried several procedures, but i cant get rid of the pwd...

i've made a dump with AFUWINx64.EXE

can you help me?

thx...

[mitchw]

Got a MacBook Pro M1 Pro 16'' to rescue immediately after liquid accident - I got it in less than 30 minutes after the spill.
It got spilled from behind when the laptop was closed. It mostly affected the rear of the mainboard and the bottom of the LCD.

I quickly took it apart and washed the liquid residue off the mainboard.
The area around the UP800 had some light corrosion, but it just washed away with some IPA. Other areas looked undamaged.

The mainboard got a thorough cleaning, as did the top case and LCD connectors / cables.

Now the laptop...