help with graphics driver for eMachine G725

[harp]

I am trying to find graphics driver for old laptop eMachine G725, for winxp 32bit... from data on internet, https://gadgetaz.com/Laptop/eMachines_G725--1942 it will have Intel GMA 4500MHD graphics, so I downloaded a few of them but nothing work, error say: this computer does not meet the minimum requirements for installing the software. So, please somebody help me to find bare minimum graphics driver to see non deformed screen anymore...

[Arafat91]

Need bios
Motherboard-ZS040 LA-A993P REV-1.0
My brackup bios black screen...

[zaratustrax]

Greetings.
I have dowloaded a Dell bios exe from the web page. After extracted it the folder generated is as showed in the picture. The bios is Taken apart in several files.

If I use ME Analyzer, the Flash Image tools is 16.1 version but I cannot find this versión.

So My question is how can I get the full bios or how to glue all the pieces to get the whole file?
Thanks for your help...

[Rass]

Hi,
I have an MSI Pro X670p Wi-Fi. When I boot directly with the CPU and memory, the red CPU LED and orange DRAM LED light up.
I tried updating the BIOS with QFlash from USB, and there's a signal from pin 2. I checked all voltages and they're OK, including coils, chipset, BIOS, etc. I checked the pins between the CPU and RAM.
I've also tried swapping the CPU for another one that's working in my personal PC and moving memory to different slots.
If anyone has any ideas or suggestions, I'm at a standstill...
If possible and if someone has a schematic it would also be...

[wizare]

i am looking for the asrock h81m-itx/wifi bios. thank you in advance

[Pingas]

Hi friends, I need a bin dump from a mac 820-02862 256GB

[Pieter12345]

I'm looking for the GV-N970WF3OC-4GD REV:1.1 boardview (REV:1.0 would likely also suffice).

I did get my hands on the schematics (Gigabyte_GV-N970WF3OC-4GD_Rev_1.1_.pdf) and a similar boardview (GV-N970TTOC-4GD_Rev_1.0_BoardView.tvw), but these are not sufficient for my needs.

Thanks in advance!

[bluto]

This is from the power supply of an LED shop light. The light went completely dead suddenly. I removed the SMPS board and it looked really good except for some bad solder joints. I touched all of them up but the light was still dead. I then found this open resistor that was between the neutral wire of the plug and the transformer. The color bands seem non-standard. Does it indicate 13 ohm, 30 ohm...? I am not sure. What should I replace this with?


...