Power Supply 2273+3362 PSU in STBY
 

Got a PSU that I can't seem to find a manual for "Power Supply 2273+3362".

5V and 12V is present and I PS/On bridged turned on the backlights although the led were flickering and could be culprit as the monitor has been idle for some time.

D2 Diode has 12V on both sides which seems a bit strange?

Re: PSU in STBY
 

C910 and R901 solder joints look a little suspect. If you have an ESR meter check all the electrolytics

Re: Power Supply 2273+3362 PSU in STBY
 

As do both solder joints on R930.

Re: PSU in STBY
 

I don't have an ESR meter but I already changed out 3 caps that were swollen, I think the problem is in the low voltage switching or the led

Re: Power Supply 2273+3362 PSU in STBY
 

If D2 voltage is 12v on both sides it because the led boost circuit is not working, likely cause is an open led in the backlight circuit. If the backlight is open, the circuit will go into over voltage protection and shut down.

Re: Power Supply 2273+3362 PSU in STBY
 

Correct, bridging PS/ON indicates a power loss when the led strip is connected and will put the rest of the system in protection.

I've removed the led strip and will consider ordering it.

Thanks you all for the input.