Badcaps.net Forum
Go Back   Badcaps Forums > Search Forums
Register FAQ Calendar Search Today's Posts Mark Forums Read

Showing results 1 to 25 of 500
Search took 0.02 seconds.
Search: Posts Made By: Agent24
Forum: Troubleshooting Audio Equipment 03-17-2022, 04:44 PM
Replies: 2
Views: 394
Posted By Agent24
Re: Denon AVR-X2000 no audio

Depends what the fuses protect. Are they in the power supply? Or do they protect the speaker outputs? Or what? Hard to tell from the photo.
Forum: Troubleshooting Audio Equipment 03-17-2022, 02:16 PM
Replies: 3
Views: 418
Posted By Agent24
Re: SONOS Play 1 no power burnt out component

Check your main filter capacitor too. If it's bad, that could be why the MOSFET blew to begin with. The MOSFET snubber network is also suspect.

I would also check diodes etc around the FAN6751,...
Forum: Troubleshooting Audio Equipment 03-17-2022, 02:05 PM
Replies: 1
Views: 288
Posted By Agent24
Re: Allen & Heath Xone:92 (DJ mixer) no output on main out & magic smoke

It does look like only those op-amps are powered through those resistors, so aside from C58/C60 (which would both have to go shorted at the same time, and is unlikely) it is most likely one of the...
Forum: General Computer & Tech Discussion 02-02-2022, 09:35 PM
Replies: 30
Views: 1,419
Posted By Agent24
Re: Trying to renew my old computer

That's why you have to strip it down to bare minimum parts before looking at BIOS etc.

Other bad devices always have the chance to cause problems.
Forum: Troubleshooting Desktop Motherboards, Graphics Cards, and PC Peripherals 01-28-2022, 03:43 AM
Replies: 2
Views: 329
Posted By Agent24
Re: MSI GTX1070 not recognized on H110 Board, Z490 OK

Could it be that the card is fine but just incompatible with the other board?
Forum: General Capacitor Questions & Issues 01-27-2022, 10:05 PM
Replies: 27
Views: 2,070
Posted By Agent24
Re: Sacon FZ revival experiment

Sacon FZ are so crap, they probably use fake cat piss.
Forum: Troubleshooting Power Supplies and Power Supply Design 11-22-2021, 12:03 PM
Replies: 3,195
Views: 1,076,102
Posted By Agent24
Re: Power supply build quality pictorial. part 2

What a fascinating design! I want one just for the sheer novelty.
Forum: Troubleshooting Game Consoles & Other Weird Devices 09-25-2021, 06:27 PM
Replies: 84
Views: 9,407
Posted By Agent24
Re: Catapillar ECU repair, need N548AB replacement?

Oh I must have missed that.
It could possibly be designed to draw heat up the pins and dissipate out through the back plate?

I've seen mini heatsinks on a slot A motherboard that were soldered to...
Forum: Troubleshooting Game Consoles & Other Weird Devices 09-25-2021, 05:10 AM
Replies: 84
Views: 9,407
Posted By Agent24
Re: Catapillar ECU repair, need N548AB replacement?

I'm half asleep but that didn't look much like a transistor. It doesn't seem to have a company logo either??

It looks like a hunk of metal.

I wonder if the device is actually a heatsink to help...
Forum: General Computer & Tech Discussion 09-24-2021, 08:25 PM
Replies: 36
Views: 9,779
Posted By Agent24
Re: never trust samsung

I never wanted a smart TV and now I want one even less.

It's fine, you can get regular TVs for free when other people "upgrade" haha
Forum: Troubleshooting Game Consoles & Other Weird Devices 09-17-2021, 07:51 PM
Replies: 84
Views: 9,407
Posted By Agent24
Re: Catapillar ECU repair, need N548AB replacement?

Hopefully not the case here if both are measuring the same, but I've seen MOSFETs that blew hard enough that they went open circuit after the event, while acting as a fuse for the now dead-shorted...
Forum: General Capacitor Questions & Issues 06-30-2021, 12:29 PM
Replies: 9
Views: 1,623
Posted By Agent24
Re: recap help AcBel PSU

Nothing so wrong with using recycled capacitors IF you remember you don't know how much longer they're going to last. You might have to replace them again in 6 months- if you're okay with that.
...
Forum: General Electronics Technical Discussion 04-24-2021, 03:53 PM
Replies: 84
Views: 6,497
Posted By Agent24
Re: LED Resistor Calculations ...

The side view drawing shows the right pad and lower pad as the same physical piece.

They could have stated it specifically, but dealing with vague datasheets is another joy of design! If in doubt...
Forum: General Electronics Technical Discussion 04-24-2021, 01:13 PM
Replies: 92
Views: 7,412
Posted By Agent24
Re: Swapping out a NiMh for a LiPo?

Sharp inner corners (45 degrees and below) can create an "acid trap" that could cause undercutting of the trace during etching.

Also, sharp angles are no good for high frequency signals, so traces...
Forum: General Electronics Technical Discussion 04-23-2021, 09:00 PM
Replies: 4
Views: 769
Posted By Agent24
Re: Theory behind "sometime works, sometime doesn't"

Keep watching to 7:38... the track was broken at the test pad due to corrosion.
Forum: General Electronics Technical Discussion 04-23-2021, 04:27 PM
Replies: 4
Views: 878
Posted By Agent24
Re: What's the use use of these things?

It can also be to protect against vibration/abrasion damage.
Forum: General Electronics Technical Discussion 04-23-2021, 04:22 PM
Replies: 7
Views: 1,004
Posted By Agent24
Re: What is the resistor value?

I can see what looks like a solder bridge next to the bottom right (pin 8) of the LA4570, from a through hole component to an SMD capacitor.

I also notice discolouration on some tracks and VIAs on...
Forum: General Electronics Technical Discussion 04-23-2021, 04:07 PM
Replies: 84
Views: 6,497
Posted By Agent24
Re: LED Resistor Calculations ...

While the precision of components has improved over the years, no two components are manufactured exactly the same, so no, there is no exact voltage. That's why they give a range, or just specify the...
Forum: General Computer & Tech Discussion 04-23-2021, 03:31 PM
Replies: 10
Views: 2,743
Posted By Agent24
Re: Black plastic goo question.

I've seen a few devices where rubberised or rubber parts turned to gloop but many more where they didn't, including things that are decades old. There doesn't seem to be any pattern to it.

In my...
Forum: General Computer & Tech Discussion 04-23-2021, 03:24 PM
Replies: 11
Views: 1,220
Posted By Agent24
Re: How to avoid shitty "McWires"?

Those wires have fewer strands than usual, too, which makes them more susceptible to breaking.
Forum: Troubleshooting Audio Equipment 03-18-2021, 06:52 PM
Replies: 174
Views: 11,831
Posted By Agent24
Re: Crown Amp DC300A - One channel distirted, other good.

Outputs: Output transistors (usually the most expensive ones)
Subs: Substitutes
Forum: Troubleshooting Audio Equipment 03-18-2021, 01:00 PM
Replies: 174
Views: 11,831
Posted By Agent24
Re: Crown Amp DC300A - One channel distirted, other good.

I find it interesting it broke when you 1) changed inputs 2) changed volume

I can imagine each of these actions has possibility to create a noise burst from dirty switch and potentiometer...
Forum: General Capacitor Questions & Issues 03-15-2021, 12:45 PM
Replies: 12
Views: 1,308
Posted By Agent24
Re: Identify diode

Looks like the switching MOSFET for the LED backlight driver. Driven from pin 26 of that EUP2589. Pretty weird though that the silkscreen for that MOSFET reads the pin labels like a linear regulator!...
Forum: General Capacitor Questions & Issues 03-15-2021, 12:40 PM
Replies: 12
Views: 1,308
Posted By Agent24
Re: Identify diode

Even if not used as a rectifier?
Forum: General Capacitor Questions & Issues 03-14-2021, 11:52 PM
Replies: 12
Views: 1,308
Posted By Agent24
Re: Identify diode

322C is probably the date code given that 5100B matches a diode that does exist, and one of those SB5100s would make sense given its use in circuit.

100v is just the maximum reverse voltage, it...
Showing results 1 to 25 of 500

 
Forum Jump


Badcaps.net Technical Forums 2003 - 2022
Powered by vBulletin ®
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.
All times are GMT -6. The time now is 01:51 PM.
Did you find this forum helpful?