Badcaps.net Forum
Go Back   Badcaps Forums > Search Forums
Register FAQ Calendar Search Today's Posts Mark Forums Read

Showing results 1 to 25 of 500
Search took 0.02 seconds.
Search: Posts Made By: Per Hansson
Forum: Troubleshooting Power Supplies and Power Supply Design Today, 11:56 AM
Replies: 28
Views: 578
Posted By Per Hansson
Re: Learning with ATX CHIEFTEC 450W PSU

I would say it is still starved for power, but you really should check the integrity of the APFC swiching mosfets (Q11/Q12 & Q1/Q3 from the schematic kaboom posted) if you do suspect that the supply...
Forum: Troubleshooting Power Supplies and Power Supply Design Today, 03:50 AM
Replies: 28
Views: 578
Posted By Per Hansson
Re: Learning with ATX CHIEFTEC 450W PSU

What voltage do you read on the primary capacitor during this test?
If your line voltage is 230VAC then it should be around 230VAC x √2 = 325VDC in standby.
And when you start it up it should be...
Forum: General Capacitor Questions & Issues 06-21-2022, 10:28 AM
Replies: 6
Views: 144
Posted By Per Hansson
Re: Cleaning up capacitor leakage

I would recommend cleaning using acetic acid if it leaked on the board.
Every time I do I can see bubbles and hear fizzing as I put it on the areas with leaked electrolyte, so it does a chemical...
Forum: Troubleshooting Power Supplies and Power Supply Design 06-21-2022, 09:52 AM
Replies: 28
Views: 578
Posted By Per Hansson
Re: Learning with ATX CHIEFTEC 450W PSU

As I explained in my previous post it will be different for each PSU design.
What works on this one will obviously not work on another with a different APFC controller and there are many of those!
...
Forum: Troubleshooting Power Supplies and Power Supply Design 06-20-2022, 01:35 PM
Replies: 28
Views: 578
Posted By Per Hansson
Re: Learning with ATX CHIEFTEC 450W PSU

It is disabled, but as stated in the datasheet you can't be sure it has 0% duty cycle.
It is better to desolder the OVP/EN pin as that has the sole purpose of enabling the circuit.
Every power...
Forum: Troubleshooting Power Supplies and Power Supply Design 06-20-2022, 10:06 AM
Replies: 28
Views: 578
Posted By Per Hansson
Re: Learning with ATX CHIEFTEC 450W PSU

Well, maybe try desoldering the whole APFC board then, I'm not sure it is disabled now.
Or disconnect the OVP/EN pin instead.
Forum: Troubleshooting Power Supplies and Power Supply Design 06-20-2022, 08:00 AM
Replies: 28
Views: 578
Posted By Per Hansson
Re: Learning with ATX CHIEFTEC 450W PSU

Try to increase to a 120w bulb, you can of course use two parallel 60w bulbs instead...

Also note the remark in the datasheet about grounding the SS pin:
Note: In an open-loop test circuit,...
Forum: Troubleshooting Power Supplies and Power Supply Design 06-19-2022, 03:17 AM
Replies: 28
Views: 578
Posted By Per Hansson
Re: Learning with ATX CHIEFTEC 450W PSU

Ok, the original Samxon capacitor is fine, remember that capacitors have a +/- 20% tolerance rating...

To test the power supply without APFC you can either ground the UCC3818N APFC controller...
Forum: Troubleshooting Audio Equipment 06-18-2022, 02:03 PM
Replies: 85
Views: 1,435
Posted By Per Hansson
Re: Sony STR-DN1030 Distorted audio when Volume adjusted

CapLeaker: As is the videos are too big to upload, they can be converted in VLC to be smaller.
I did try and after conversion they are ok, but it would waste allot of server storage space if videos...
Forum: Troubleshooting Power Supplies and Power Supply Design 06-18-2022, 11:29 AM
Replies: 28
Views: 578
Posted By Per Hansson
Re: Learning with ATX CHIEFTEC 450W PSU

I don't have a good answer, but you can't bring up a APFC PSU on such a low wattage bulb.
Look at my post here for an example of what you can try:...
Forum: Troubleshooting Power Supplies and Power Supply Design 06-18-2022, 03:14 AM
Replies: 28
Views: 578
Posted By Per Hansson
Re: Learning with ATX CHIEFTEC 450W PSU

45.2,14.4 (https://www.google.com/maps/place/4512'00.0"N+1424'00.0"E) is in the Adriatic Sea, so I would guess 230VAC on a raft between Krk and Opatija :D
Forum: Troubleshooting Power Supplies and Power Supply Design 06-18-2022, 03:04 AM
Replies: 54
Views: 1,547
Posted By Per Hansson
Re: Cyberpower CP900EPFCLCD - F03 Error

Well you probably will not find that on sites like eBay, what you need is some basic electronic components.
They could even be harvested from some old PC power supply for example.

But ST also...
Forum: Troubleshooting Power Supplies and Power Supply Design 06-18-2022, 01:21 AM
Replies: 28
Views: 578
Posted By Per Hansson
Re: Learning with ATX CHIEFTEC 450W PSU

Usually when you hear sounds like you describe it can be caused by a failing primary bulk capacitor.
So I would try to measure the primary capacitor for both ESR and capacitance.
It might just be...
Forum: Troubleshooting Power Supplies and Power Supply Design 06-17-2022, 10:27 AM
Replies: 54
Views: 1,547
Posted By Per Hansson
Re: Cyberpower CP900EPFCLCD - F03 Error

There is not much use to test it without the transformer, the issue likely lies in or after it.
But sure, I don't think it would hurt, especially if you use the light bulb for current limit...

...
Forum: Equipment Usage, Soldering, Techniques, and Reviews 06-17-2022, 10:22 AM
Replies: 9
Views: 202
Posted By Per Hansson
Re: For laptop/PC repair what V and A rating should my probes be?

No sam_sam_sam the Fluke TL175 are not useful for troubleshooting a laptop mainboard.
They are great for industrial use though.

The Fluke TL-910 are great so long as they don't loose grip of the...
Forum: General Electronics Technical Discussion 06-16-2022, 09:40 AM
Replies: 41
Views: 1,665
Posted By Per Hansson
Re: Milwaukee Battery Charger M18/M12 Dual battery charger Dead no light during charg

What stj said, I would also measure the capacitance of the supposed bad caps and see what they read:
As that is anyway the most important metric for a startup capacitor.
Forum: Troubleshooting Power Supplies and Power Supply Design 06-16-2022, 09:26 AM
Replies: 54
Views: 1,547
Posted By Per Hansson
Re: Cyberpower CP900EPFCLCD - F03 Error

Well one thing you could do then is desolder the transformer and build a circuit from the Viper datasheet using it:
They do provide an example circuit in there for a charger...

And yes I meant to...
Forum: Troubleshooting Desktop Motherboards, Graphics Cards, and PC Peripherals 06-13-2022, 02:34 AM
Replies: 4
Views: 169
Posted By Per Hansson
Re: MGX7520 onboard graphics problem

Now that you have two identical board a nice way could be to use a thermal camera to look for any hotspots that are not the same between the units.
Forum: Troubleshooting Power Supplies and Power Supply Design 06-13-2022, 02:32 AM
Replies: 54
Views: 1,547
Posted By Per Hansson
Re: Cyberpower CP900EPFCLCD - F03 Error

Do you have some way to measure the high frequency transformer?
I never tried but I guess even the cheap "component tester...
Forum: Troubleshooting Desktop Motherboards, Graphics Cards, and PC Peripherals 06-10-2022, 12:02 PM
Replies: 4
Views: 197
Posted By Per Hansson
Re: Gigabyte Z390 Aorus Master No POST

You write that it tries to run from the backup BIOS:
Are you sure whatever BIOS is stored on the backup BIOS supports the processor?
Forum: Troubleshooting Power Supplies and Power Supply Design 06-10-2022, 11:50 AM
Replies: 52
Views: 19,249
Posted By Per Hansson
Re: Mitsubishi Melservo MR-J2S-100A alarm: AL.E9

Yes exactly, just be sure to check what module is actually installed on your unit, because they can have different revisions...
I bought one from eBay seller bestmodule...
Forum: General Electronics Technical Discussion 06-09-2022, 11:54 AM
Replies: 7
Views: 171
Posted By Per Hansson
Re: Can halogen bulb flicker?

This type of lamp with the two small pins is notorious for developing a bad connection!
Either the pins oxidize or the contact receptacle do, or the springs in the receptacle become too weak causing...
Forum: General Electronics Technical Discussion 06-05-2022, 04:28 AM
Replies: 7
Views: 243
Posted By Per Hansson
Re: Can not find Model/Value of Thermistor.

If you can calibrate the curve the thermistor redwire suggested is a good example.
It actually exists in a version with a beta value of 4599K which I think is the correct part: TH513F45GBSN
I...
Forum: General Computer & Tech Discussion 06-03-2022, 10:12 AM
Replies: 52
Views: 2,537
Posted By Per Hansson
Re: Topcat's Ultimate Pentium 4 Retro Gamer!

Well the lighting makes ALL the difference, without that it would be rated for only 180W continuous :D
Forum: Troubleshooting Computer Displays 05-31-2022, 12:04 PM
Replies: 3
Views: 172
Posted By Per Hansson
Re: Eizo ColorEdge CG277 power supply burned

This is a special part, I think your only hope is to buy one from the component distributors in China, or ask Eizo if they sell the board?
The only data I was able to find is the attached document...
Showing results 1 to 25 of 500

 
Forum Jump


Badcaps.net Technical Forums 2003 - 2022
Powered by vBulletin ®
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.
All times are GMT -6. The time now is 04:43 PM.
Did you find this forum helpful?