Announcement

Collapse
No announcement yet.

Add Stereo Input To Hi-Fi (Sony SONY PMC 107L)

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Add Stereo Input To Hi-Fi (Sony SONY PMC 107L)

    Hi.
    I bought a Cheap HIFI to use as my PC output and speakers and forgot to check if it had an input. It doesn't.

    Is there any way to add a stereo input. I have a bunch of Phono sockets I am not using.
    Where in the circuit is the best place to solder the 3 stereo input wires?

    This is the model and schematics:

    https://www.manualslib.com/manual/91...7l.html#manual

    #2
    Re: Add Stereo Input To Hi-Fi (Sony SONY PMC 107L)

    r108 r208 should do it

    Comment


      #3
      Re: Add Stereo Input To Hi-Fi (Sony SONY PMC 107L)

      i wouldnt - that will bypass the controls.
      it would be better to tap the signal from the tape or cd section so you still have use of the controls - and keep the tuner working

      Comment


        #4
        Re: Add Stereo Input To Hi-Fi (Sony SONY PMC 107L)

        tape:
        R105 & R205

        cd:
        R113 & R213
        Last edited by stj; 10-31-2023, 05:00 AM.

        Comment


          #5
          Re: Add Stereo Input To Hi-Fi (Sony SONY PMC 107L)

          Originally posted by stj View Post
          tape:
          R105 & R205

          cd:
          R113 & R213
          Thanks everyone.
          Where do i connect the negative wire?

          Comment


            #6
            Re: Add Stereo Input To Hi-Fi (Sony SONY PMC 107L)

            Can i solder the negative wire to any suitable ground on that main board.
            Eg: On the volume control ground marked blue circle in the jpeg?
            Attached Files

            Comment


              #7
              Re: Add Stereo Input To Hi-Fi (Sony SONY PMC 107L)

              anywhere nearby that is 0v/gnd on the schematic

              Comment


                #8
                Re: Add Stereo Input To Hi-Fi (Sony SONY PMC 107L)

                Originally posted by stj View Post
                i wouldnt - that will bypass the controls.
                it would be better to tap the signal from the tape or cd section so you still have use of the controls - and keep the tuner working
                computer should have a mixer and radio . be just like using main in on a proper amp . .
                could add pre out main in then send pre out to computer ..
                Last edited by petehall347; 10-31-2023, 05:12 PM.

                Comment

                Working...
                X