View Single Post
Old 08-16-2021, 07:29 PM   #42
Badcaps Veteran
Join Date: Jul 2011
City & State: Some times Sunny Jacksonville FL
My Country: USA
Line Voltage: 120 Volts 60 HZ
I'm a: Knowledge Seeker
Posts: 3,107
Default Re: Is there a way to modify a IMAX b6 battery tester version 2 to only monitor volta

The software has a few bugs in and especially when it has been running a long time some functions freeze and are unresponsive and one of them being going to full screen viewer is a little buggy to being with even when just viewing when restarting the computer

One other bug it has is if you want to discharge a single cell you set your current for one amp however if you have a four cell battery pack it limit you to 350 milliamperes which is crap I want one amp discharging current

This is just one more limitation of this charger that I have to get use to

The charging current is not limited to less than one amp and normally I do not use anything higher than this
anyway I have tried to see what the limit is yet
9 PC LCD Monitor
6 LCD Flat Screen TV
30 Desk Top Switching Power Supply
10 Battery Charger Switching Power Supply for Power Tool
6 18v Lithium Battery Power Boards for Tool Battery Packs
1 XBox 360 Switching Power Supply and M Board
25 Servo Drives 220/460 3 Phase
6 De-soldering Station Switching Power Supply 1 Power Supply
1 Dell Mother Board
15 Computer Power Supply
1 HP Printer Supply & Control Board * lighting finished it *

These two repairs where found with a ESR meter...> Temp at 50*F then at 90*F the ESR reading more than 10%

1 Over Head Crane Current Sensing Board ( VFD Failure Five Years Later )
2 Hem Saw Computer Stack Board

All of these had CAPs POOF
All of the mosfet that are taken out by bad caps

Last edited by sam_sam_sam; 08-16-2021 at 07:38 PM..
sam_sam_sam is offline   Reply With Quote