Hello folks,
(First post of mine, after introduction).
I came here to seek help for a board SPI reprogramming.
The referred board belongs to an Archer C9 V.4 EU router, which I believe, is bricked, (I was the one to brick it during a flashing operation with custom dd-wrt firmware upgrade).
The IC that I want to flash is this one:
Datasheet for the IC in question .
The one in the motherboard has 16 pins. (There are other IC in the motherboard, with 8 pins each, but I am almost positive that the one that will hold the CFE that I own, and that was previously backed up, would be the aforementioned 16 pin IC from winbond).
The question is:
how should I go about (assuming it is possible) to use the 16 clip/clamp together with the ch341a programmer?
Thank you for your time and patience.
Cheers
(First post of mine, after introduction).
I came here to seek help for a board SPI reprogramming.
The referred board belongs to an Archer C9 V.4 EU router, which I believe, is bricked, (I was the one to brick it during a flashing operation with custom dd-wrt firmware upgrade).
The IC that I want to flash is this one:
Datasheet for the IC in question .
The one in the motherboard has 16 pins. (There are other IC in the motherboard, with 8 pins each, but I am almost positive that the one that will hold the CFE that I own, and that was previously backed up, would be the aforementioned 16 pin IC from winbond).
The question is:
how should I go about (assuming it is possible) to use the 16 clip/clamp together with the ch341a programmer?
Thank you for your time and patience.
Cheers
Comment