Re: Trying to De-solder an Xbox Elite series 2 gaming controller.
You are going to have issues with multi-layer boards are sometimes hard to work with
I have had to use a Desoldering Gun and a temperature controlled hot air gun
You do have to practice using this setup on boards that you do not give a shit about
__________________
9 PC LCD Monitor
6 LCD Flat Screen TV
30 Desk Top Switching Power Supply
10 Battery Charger Switching Power Supply for Power Tool
6 18v Lithium Battery Power Boards for Tool Battery Packs
1 XBox 360 Switching Power Supply and M Board
25 Servo Drives 220/460 3 Phase
6 De-soldering Station Switching Power Supply 1 Power Supply
1 Dell Mother Board
15 Computer Power Supply
1 HP Printer Supply & Control Board * lighting finished it *
These two repairs where found with a ESR meter...> Temp at 50*F then at 90*F the ESR reading more than 10%
1 Over Head Crane Current Sensing Board ( VFD Failure Five Years Later )
2 Hem Saw Computer Stack Board
All of these had  CAPs POOF
All of the mosfet that are taken out by bad caps
Last edited by sam_sam_sam; 08-14-2020 at 05:14 PM..
|