Announcement

Collapse
No announcement yet.

Panasonic SA-HT820V Home Theater System

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    #61
    Re: Panasonic SA-HT820V Home Theater System

    Originally posted by R_J View Post
    200ma 200v would be the minimum, that -30v supply is fairly low current, so any fast recovery diode greater than 200ma/200v would work.
    Ok, I'll get some and try it out. I appreciate your help so far.

    Comment


      #62
      Re: Panasonic SA-HT820V Home Theater System

      Got the part and soldered it. Nothing shows up on the display. It powers up tho because the vhs side starts up. The connector tape is fine.
      Attached Files

      Comment


        #63
        Re: Panasonic SA-HT820V Home Theater System

        And the voltage is?

        Comment


          #64
          Re: Panasonic SA-HT820V Home Theater System

          Originally posted by R_J View Post
          And the voltage is?
          Pin number 6 is reading .6V. All other pins are good.
          Last edited by CapsDude; 03-16-2021, 07:12 PM.

          Comment


            #65
            Re: Panasonic SA-HT820V Home Theater System

            Originally posted by CapsDude View Post
            Pin number 6 is reading .6V. All other pins are good.
            Without -30 volts you won't get a display. To make sure there are no shorts on that line, CARFULLY remove the flat cable from P1102 and check if the negative -30v is on TL1030, if not, Unplug the unit and check the resistance of TL1030 to ground, it should be very high. Then as a last check, measure the transformer winding resistance It can be checked between D1270 cathode and ground (W56)
            Last edited by R_J; 03-16-2021, 07:40 PM.

            Comment


              #66
              Re: Panasonic SA-HT820V Home Theater System

              Didn't get -30 on TL1030.

              TL1030 read 7.8 M Ohms
              D1270 read 4.6 M Ohms

              Comment


                #67
                Re: Panasonic SA-HT820V Home Theater System

                Originally posted by CapsDude View Post
                Didn't get -30 on TL1030.

                TL1030 read 7.8 M Ohms
                D1270 read 4.6 M Ohms
                If D1270 cathode (white band) to ground measures 4.6M Ohms you either damaged a trace or the transformer winding is open.
                Attached Files
                Last edited by R_J; 03-17-2021, 10:45 AM.

                Comment


                  #68
                  Re: Panasonic SA-HT820V Home Theater System

                  Originally posted by R_J View Post
                  If D1270 cathode (white band) to ground measures 4.6M Ohms you either damaged a trace or the transformer winding is open.
                  Any way to find out if it's either one of those?

                  Comment


                    #69
                    Re: Panasonic SA-HT820V Home Theater System

                    Originally posted by CapsDude View Post
                    Any way to find out if it's either one of those?
                    Nope, no way to tell

                    Comment

                    Working...
                    X