It will just click on and off twice then nothing. Most voltage reading I only get when it's clicking then gone except standby.
CN801
PS On 3.2
STBY 5.28
GND 0
D15v 15.4
GND 0
GND 0
D5.3 5.26
D5.3. 5.26
GND 0
D15v 15.4
D15v 15.4
Again only while clicking on do I get correct voltages.
CN802
D5.3v. 5.3
D5.3v. 5.3
GND 0
GND 0
Ps on 3.2
Vs on 3.2
CN803
Not sure if this says V5 or VS
V5 17-18 range
V5 17-18 range
GND 0
GND 0
D15v 15
CN804
VA 22
GND 0
D15 15
GND 0
Vs or V5 around 18
Vs or V5 around 18
I have replaced power board, the small green board and swap eprom on connection board. I have also have unplugged each board and powered on but to no avail.
CN801
PS On 3.2
STBY 5.28
GND 0
D15v 15.4
GND 0
GND 0
D5.3 5.26
D5.3. 5.26
GND 0
D15v 15.4
D15v 15.4
Again only while clicking on do I get correct voltages.
CN802
D5.3v. 5.3
D5.3v. 5.3
GND 0
GND 0
Ps on 3.2
Vs on 3.2
CN803
Not sure if this says V5 or VS
V5 17-18 range
V5 17-18 range
GND 0
GND 0
D15v 15
CN804
VA 22
GND 0
D15 15
GND 0
Vs or V5 around 18
Vs or V5 around 18
I have replaced power board, the small green board and swap eprom on connection board. I have also have unplugged each board and powered on but to no avail.
Comment