View Single Post
Old 06-07-2021, 04:54 PM   #1
vrasp
Senior Member
 
Join Date: Nov 2019
City & State: Toronto
My Country: Canada
I'm a: Knowledge Seeker
Posts: 174
Default Fixing a laboratory waterbath

Hey all,

I ve narrowed the issue down to the board you see in the picture. The round fuse works, the other components have not been tested(not sure how to). I believe the issue might be from the transformer but can't find anything online about that part. This is a bit over my skill level. I am able to solder new parts if needed.
Here are the things I believe I should do next:

How would I find a similar transformer online? Can I test this transformer with my multimeter?

I also found the manual for this device. http://www.hvg-verwertung.de/ebay/do...da/RMS6_20.pdf
It has a schematic. The board that is on the picture is number 24 and the transformer is number 26. Not sure if this info is of any use.

Any help would be greatly appreciated!

https://ibb.co/DpHccBp

Kindly,

Vrasp




Last edited by vrasp; 06-07-2021 at 05:00 PM..
vrasp is offline   Reply With Quote