View Single Post
Old 06-09-2021, 05:24 PM   #20
vrasp
Senior Member
 
Join Date: Nov 2019
City & State: Toronto
My Country: Canada
I'm a: Knowledge Seeker
Posts: 174
Default Re: Fixing a laboratory waterbath

Yes. I was trying to remove it with a heat gun while pulling. It wouldnt come off. I eventually pulled hard thinking the pins would rip off the board but they ripped off the transformer instead. I dont mind getting independent transformers. I just need to figure out which lines were 15v , 20v and 8v on the board. I tried following the lines to see what components they are connected to (on another board that is not shown on pics) and see what voltages they are rated at. Is that a good idea? Is there another way I dont know about?
vrasp is offline   Reply With Quote