Badcaps Forums - View Single Post - Tefal GV8962 Pro Express steam iron

**beetle1303** · 10-25-2020, 07:11 AM

I gotten a new LNK304PN, and it reads 5M+ ohm between Drain Pin and each of the 4 Source Pin.
I removed the shorted chip (it reads 28ohm between Drain and Source), and soldered back D3, and it still reads 30 both directions.. I think the circuit is shorted somewhere because it already measured 30 between the 2 solder points before D3 is re-inserted.

10-25-2020, 07:11 AM	#12
beetle1303 Senior Member Join Date: Jul 2019 City & State: Singapore My Country: Singapore Line Voltage: 230VAC 60Hz I'm a: Knowledge Seeker Posts: 169	Re: Tefal GV8962 Pro Express steam iron - no power I gotten a new LNK304PN, and it reads 5M+ ohm between Drain Pin and each of the 4 Source Pin. I removed the shorted chip (it reads 28ohm between Drain and Source), and soldered back D3, and it still reads 30 both directions.. I think the circuit is shorted somewhere because it already measured 30 between the 2 solder points before D3 is re-inserted.