Hi everyone,
I have a LG plasma TV, model 50PA6500-UG that has recently stopped working. Would click when it was powered on then turn off again, had standby light working when off. Did some troubleshooting and determined that the Ysus board was no good so I replaced it.
Now all I get is random pixels going down the screen(Mostly red), menus function but do not come up on screen(can change output, change channels and adjust volume. Don’t know where the remote is, someone in the house lost it. So I am stuck with the controls on the front of the TV.
Both Ysus buffer boards appear good and ribbon cables have no damage.
Let me know where to start troubleshooting. Have a multimeter and soldering station. Can provide pictures if needed. Thank you.
I have a LG plasma TV, model 50PA6500-UG that has recently stopped working. Would click when it was powered on then turn off again, had standby light working when off. Did some troubleshooting and determined that the Ysus board was no good so I replaced it.
Now all I get is random pixels going down the screen(Mostly red), menus function but do not come up on screen(can change output, change channels and adjust volume. Don’t know where the remote is, someone in the house lost it. So I am stuck with the controls on the front of the TV.
Both Ysus buffer boards appear good and ribbon cables have no damage.
Let me know where to start troubleshooting. Have a multimeter and soldering station. Can provide pictures if needed. Thank you.
Comment