Re: Desoldering help
Or if you have a soldering tweezers would also work but you would have to add some more solder to the mounting tabs and pins
Or remove the solder from the pins and add more solder to the tabs and remove the part when the solder has melted and is flowing
Which ever method you decide to do you will have to use more heat maybe as high as 800*F make sure your tweezers are up to temperature before you start
If you use a temperature controlled hot air gun turn up the heat and turn down the air flow but do not turn the air flow to low and do it from the back of the part too the edges of the board and keep moving around the part until it comes loose from the board
__________________
9 PC LCD Monitor
6 LCD Flat Screen TV
30 Desk Top Switching Power Supply
10 Battery Charger Switching Power Supply for Power Tool
6 18v Lithium Battery Power Boards for Tool Battery Packs
1 XBox 360 Switching Power Supply and M Board
25 Servo Drives 220/460 3 Phase
6 De-soldering Station Switching Power Supply 1 Power Supply
1 Dell Mother Board
15 Computer Power Supply
1 HP Printer Supply & Control Board * lighting finished it *
These two repairs where found with a ESR meter...> Temp at 50*F then at 90*F the ESR reading more than 10%
1 Over Head Crane Current Sensing Board ( VFD Failure Five Years Later )
2 Hem Saw Computer Stack Board
All of these had  CAPs POOF
All of the mosfet that are taken out by bad caps
Last edited by sam_sam_sam; 10-04-2021 at 06:16 PM..
|