I have a gigabyte 8I865GME-775-RH that will power on, but sticks at the post screen. If I press del to enter the bois setup, it will show "entering setup" but then stick there. Same thing happens if I try to go into the built in flash utility.
I have tested my cpu and ram on another motherboard and they appear to work correctly. I have also cleared the cmos and pulled it's battery. So I'm pretty sure the problem is with the board.
This motherboard was working fine until a Antec 350 watt power supply that was being used with it failed. I opened the PSU and found 4 swollen caps. It was working fine one day and then when I went to reboot the system the board stopped posting. Replaced the PSU and it fired up but it's stuck at hte post screen.
I do not see any swollen caps on the board, so I can no clue where to start. I don't see any brown spots on the board or anything else that would lead me to believe something failed on the board. Have you guys seen bad caps or mosfets cause this sort of issue? Thanks.
I have tested my cpu and ram on another motherboard and they appear to work correctly. I have also cleared the cmos and pulled it's battery. So I'm pretty sure the problem is with the board.
This motherboard was working fine until a Antec 350 watt power supply that was being used with it failed. I opened the PSU and found 4 swollen caps. It was working fine one day and then when I went to reboot the system the board stopped posting. Replaced the PSU and it fired up but it's stuck at hte post screen.
I do not see any swollen caps on the board, so I can no clue where to start. I don't see any brown spots on the board or anything else that would lead me to believe something failed on the board. Have you guys seen bad caps or mosfets cause this sort of issue? Thanks.
Comment