View Single Post
Old 11-16-2014, 12:34 AM   #2
budm
Badcaps Veteran
 
budm's Avatar
 
Join Date: Feb 2010
City & State: S.F. Bay area
My Country: USA
Line Voltage: 120V 60Hz
I'm a: Knowledge Seeker
Posts: 39,205
Default Re: Dell 2407 wfpb no backlight

That is one of those bad black fuse which is used alot in the CMO Inverter board for LCD TV that I replaced lots of them. I believe that is 1.5A fuse, it is used for the PWM IC on the inverter circuit. I use PICO fuse which you will have to bend the legs, no need to remove the old fuse, you can solder one end to the big copper trace and another end to C9 leg.
You can check the resistance on the right side of the fuse and circuit ground to see if it shows very low Ohm, also check the Output pin of the 5V reg to see if it shows low Ohms, that will the idea if you have shorted circuit or not.
I am not sure if that fuse feed the input pin (left pin, center pin is GND, right pin is Output) of the 7805 or not.
You can also put your meter in DCA mode to check the current draw.
Attached Images
File Type: jpg Black fuse.JPG (569.9 KB, 30 views)
File Type: jpg DSC00270.JPG (343.9 KB, 27 views)
__________________
Never stop learning
Basic LCD TV and Monitor troubleshooting guides.
http://www.badcaps.net/forum/showthr...956#post305956

Voltage Regulator (LDO) testing:
http://www.badcaps.net/forum/showthr...999#post300999

Inverter testing using old CFL:
http://www.badcaps.net/forum/showthr...er+testing+cfl

Tear down pictures : Hit the ">" Show Albums and stories" on the left side
http://s807.photobucket.com/user/budm/library/

TV Factory reset codes listing:
http://www.badcaps.net/forum/showthread.php?t=24809

Last edited by budm; 11-16-2014 at 12:43 AM..
budm is offline   Reply With Quote