I had 1 LED out on a Bauhn ATVS58-0516.
I had some spares so I took one of an old strip (after making sure it worked) and took the bad one off the strip.
I then put the replacement one on the strip.
Now all the original lights light up (same as before) but the new one doesnt.
I put the backlight tester on each side of the replacement and it lights up no problem.
What am I doing wrong? This is the first time I have tried this procedure and I thought it went well.
I had some spares so I took one of an old strip (after making sure it worked) and took the bad one off the strip.
I then put the replacement one on the strip.
Now all the original lights light up (same as before) but the new one doesnt.
I put the backlight tester on each side of the replacement and it lights up no problem.
What am I doing wrong? This is the first time I have tried this procedure and I thought it went well.
Comment