Re: Need some help with Epson Printer Power Supply.
Voltage across C51/C52 is 0volts, but it pulses up to between 1-3 when the supply comes on, immediately drops to 0 volts when the supply kicks back off.
Voltage across C-12 is a steady 165.
I measured the resistance between the +42 volt output and ground. 0.3 ohms. I would say I have a direct short somewhere on the main board!
I am guessing my hunch about the power supply was incorrect. There are several caps on the main board. I am wondering if one of those is shorted.
It does not appear any of them have leaked or are bulging.
|