Badcaps Forums - View Single Post - Dead but clicking Hanns-G HC194D?

Mafi · 10-24-2021, 06:34 PM

Ok I desoldered the one side of the four jumpers mentioned and I am still getting the same results. The only thing I can add is that I had my test leads clipped onto the output pins for the 12v and ground and as I plugged it in I noticed the voltage on my meter first flashed ~10 and then quickly worked its way down to about 6.43V. It was still 4.99 on the 5V pin. Sorry life got in the way a bit so it took a bit to get it done. Where to next?

10-24-2021, 06:34 PM	#9
Mafi New Member Join Date: Sep 2021 City & State: Minneapolis MN My Country: USA Line Voltage: 120VAC 60Hz I'm a: Knowledge Seeker Posts: 12	Re: Dead but clicking Hanns-G HC194D? Ok I desoldered the one side of the four jumpers mentioned and I am still getting the same results. The only thing I can add is that I had my test leads clipped onto the output pins for the 12v and ground and as I plugged it in I noticed the voltage on my meter first flashed ~10 and then quickly worked its way down to about 6.43V. It was still 4.99 on the 5V pin. Sorry life got in the way a bit so it took a bit to get it done. Where to next?