View Single Post
Old 12-25-2019, 10:36 AM   #14
chorumluum
New Member
 
Join Date: Dec 2019
City & State: Eskişehir
My Country: Türkiye
I'm a: Knowledge Seeker
Posts: 10
Default Re: Dell INSPIRION 15 7567 BSOD

Quote:
Originally Posted by jasko_jacker View Post
I have traced the component under check and after cleaning the card the previous values are wrong.
(LA-D991P schematic is unvailable)
The burnerd inductor receives the 19V and sends it to a double mosfet (siz980dt). This mosfet is driven by an ampec (APW8828).
I expected a short on S1 / D2 but the Ohm value is high (G1 and G2 -> 0V with motherboard ON).
What I would like to understand is if the circuit of this board page 73 LA-D751P schematic is similar. (it seems that on the alienware LA-D751P both the ram and the GPU are powered by the same 1.35VS_VGAP-> 1.35VS_VGA line but I could be wrong)
However it seems that PL901 is the voltage for VRAM.
Following the track that goes under one of the ram and which has an Ohm value of 0.50 compared to PL901 (therefore they are connected) I do not detect any short compared to GND. I don't know if it is appropriate to inject the 1.35V on PL901.
i need to near to pl-500 coil resistance can you take a makro picture this part and if you make write to value of resistance?
chorumluum is offline   Reply With Quote