Re: Help diagnosing Pyle Receiver PTA66BT with burned resistors
Ok I just tried resistance measurements in the new resistor leg and a black speaker lead
The resistor is testing just like a capacitor. I have my meter on ohms, I put red lead on resistor leg and black lead on speaker terminal, and then resistance starts at like .5, and goes up and up quickly to about 1.9 I think and then flashes OL and then jumps to 7.5 and climbs very slowly from there. When I take my probes away and put them back the resistance is slowly draining. On the way up it is kilo ohms and in the way down it is mega ohms. If I wait a min or so I can repeat the process
I took a bunch of pictures of that area of the board I will upload the best later tonight
Ok I just tried resistance measurements in the new resistor leg and a black speaker lead
The resistor is testing just like a capacitor. I have my meter on ohms, I put red lead on resistor leg and black lead on speaker terminal, and then resistance starts at like .5, and goes up and up quickly to about 1.9 I think and then flashes OL and then jumps to 7.5 and climbs very slowly from there. When I take my probes away and put them back the resistance is slowly draining. On the way up it is kilo ohms and in the way down it is mega ohms. If I wait a min or so I can repeat the process
I took a bunch of pictures of that area of the board I will upload the best later tonight
Comment