View Single Post
Old 02-24-2020, 01:19 AM   #8
Uranium-235
Muffins
 
Uranium-235's Avatar
 
Join Date: Aug 2007
City & State: tehas
My Country: US
Line Voltage: 120VAC 60Hz
I'm a: Professional Tech
Posts: 3,350
Default Re: question about Polymodding

Quote:
Originally Posted by ChaosLegionnaire View Post
no it depends on the vrm design. if it uses a high switching frequency, esr matters more so u must use the same esr or lower. u can get away with a slightly lower capacitance in that case.

if its a low switching frequency, capacitance matters more so u must use the same capacitance or higher. u can get away with a slightly higher esr.
How would one know if it used either one?
__________________
Cap Datasheet Depot: http://www.paullinebarger.net/DS/
^If you have datasheets not listed PM me
Uranium-235 is offline   Reply With Quote