Announcement

Collapse
No announcement yet.

Beko B46-LEG-6B NO View Fault

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Beko B46-LEG-6B NO View Fault

    Hi friends;

    TV's image completely gone.

    My transactions;
    https://yadi.sk/d/3fJq7VnlbL7mqA?w=1

    both of led bars have been replaced.

    I played flex on cof board (cof board>>tv display 6 quantity).The fault is not fixed.

    I disabled it in turn;T-con >cof board between flex fault is not fixed.

    Image is still distorted.

    I have read;power board(DPS-214-CP)ON CN3 socket all Voltage.

    I have read T-con board voltage.

    Could you help me;please.

    #2
    Re: Beko B46-LEG-6B NO View Fault

    hi guys;

    will nobody help me ?

    Comment


      #3
      Re: Beko B46-LEG-6B NO View Fault

      Can you post your pictures of the circuit boards on this Forum and also what voltage checks have you done and what were they?
      Willing to help but I'm no expert.

      Comment


        #4
        Re: Beko B46-LEG-6B NO View Fault

        pictures;

        [IMG][/IMG]

        [IMG][/IMG]

        [IMG][/IMG]

        [IMG][/IMG]

        Comment


          #5
          Re: Beko B46-LEG-6B NO View Fault

          view fault





          edit:add to photo
          Attached Files
          Last edited by ay_erdi; 09-01-2020, 03:56 PM.

          Comment


            #6
            Re: Beko B46-LEG-6B NO View Fault

            That does not look good. If you remove one of the ribbons from the Tcon to the panel what is the picture like. Then reconnect the ribbon and remove the other ribbon to the panel and check the picture again.

            Have you check all the voltages are correct on CN3 and CN4 of the power supply?
            Last edited by dick_barton; 09-03-2020, 09:30 AM.
            Willing to help but I'm no expert.

            Comment


              #7
              Re: Beko B46-LEG-6B NO View Fault

              I removed ribbons one by one,#5 reply view ne changed.fault goes on.

              I read on CN3 socket all voltages.CN4 socket no connected the cable ,this socket is empty

              Comment

              Working...
              X