View Single Post
Old 05-10-2021, 01:49 AM   #16
PanicMechanic
Member
 
Join Date: May 2017
City & State: Belgrade
My Country: Serbia
Line Voltage: 230V 50Hz
I'm a: Knowledge Seeker
Posts: 37
Default Re: DTK 400W PSU Power Good signal 0V fault

I actually did remove the output toroid, and checked everything under it. It all measured good. Now I have soldered it back, so too late to replace the diodes (but they do measure fine). :/

I think I have checked that cap, but I will check it again.

Everything I have been doing with PSU on the table (unloaded). I will try to load the 5V rail a bit.
PanicMechanic is offline   Reply With Quote