View Single Post
Old 10-15-2020, 12:55 PM   #7
llonen
Badcaps Veteran
 
Join Date: Sep 2014
City & State: united kingdom
My Country: hampshire
Line Voltage: 240 VAC 50Hz / 110 VAC 50 Hz and 415 VAC 50Hz
I'm a: Professional Tech
Posts: 431
Default Re: Treadmill Motor Control Board 032669-IF

I have repaired quite a lot of these over the years for customers and while I have had little success in tracking down service manuals they are generally straightforward enough to repair so long as you think of them as a smps which is essentially what they are with some logic. So in no particular order Bad solder joints, NTC, rectifier pack (usually caused by something else) electrolytic caps (the smaller ones), switching transistors, snubber caps, various relays are a weak spot and that goupy crap plastered around could do with going.

You really need to test this partly installed, hope some of this is useful and good luck with your board.

Hope this helps,
llonen is offline   Reply With Quote