View Single Post
Old 05-16-2020, 02:11 AM   #1
myth77
Senior Member
 
Join Date: Feb 2017
City & State: Split
My Country: Croatia
I'm a: Knowledge Seeker
Posts: 133
Default Replacing broken pads...

I know its insane and most of the time i use only jump wires...but sometimes when i see ripped bigger pads from board like from places where you solder bios or ite chip...i would like to make/reconstruct a new pad/pads. And it is not a problem to make it...the problem is how to glue it on board...thats where i am stuck...I tried with several glues and temperature resistance epoxies...but they all fail...when i put my solder pen..thats the end.
Maybe you have some experience on what glue or silicone to use?
myth77 is offline   Reply With Quote