View Single Post
Old 10-31-2021, 04:55 PM   #7
eccerr0r
Solder Sloth
 
eccerr0r's Avatar
 
Join Date: Nov 2012
City & State: CO
My Country: USA
Line Voltage: 120VAC 60Hz
I'm a: Hobbyist Tech
Posts: 7,203
Default Re: Motor control board

Odd both regulators are TO-3P and the board silkscreen says out-in(tab)-G which is typical for the negative rail regulator (should be in-G(tab)-out for positive). Make sure the "in" is the right voltage in any case.

These regulators are probably NOT for the motor but rather for the zillion op amps on the board that may control the motor drivers.
eccerr0r is offline   Reply With Quote