-
-
Re: Blomberg electric dryer - Need a replacement relay
I replaced the suspect relay with new, but it made no difference. The control board I ordered over a month ago is still out of stock. Any leads to an appliance parts salvage are welcome.Last edited by steves7839; 10-30-2022, 08:52 AM.Comment
-
Re: Blomberg electric dryer - Need a replacement relay
have you pulled both relays out and tested them ? did you ohm the wires off the relay that go to the coil for proper resistance ? dryers are fairly straight forward - easy to repair.
please post model #
there's one on EBAY https://www.ebay.com/itm/194280574677
marked washer but its a dryer control board that seems to be the one you need
another one cheaper - https://www.ebay.com/itm/19381880177...Bk9SR6rHnKGFYQLast edited by ajshoe; 10-30-2022, 12:08 PM.Comment
-
Re: Blomberg electric dryer - Need a replacement relay
did you check for any thermo-switches usually fitted as a final safety?Comment
-
Hello everyone,
I'm turning to the Badcaps community to help me troubleshoot the radio Rx card from my (old) garage door opener. While I could just ditch that card and replace the whole system, I first would like to understand "why" it suddenly stopped working, because that's just how I am wired...!
Some basics: the receiver works on a 30.875 Mhz frequency. Yes, I'm aware this is not in use anymore in a looot of places. It does not use any rolling code, it's just a regular dip-switch code that you have to set up on both the receiver and transmitter. The receiver... -
Hello,
I'm helping my brother to fix his Blomberg laundry dryer. He called a repair guy to have a look and the repair guy said the control board is faulty. They said the replacement board costs $400. Too expensive! 😨 My brother asks me to take a look. He has checked the door switch and thermal fuse, etc., and those seems fine.
After plugged to mains, there is no display. There is just a clicking sound from the buzzer, like one click per second. No other response.
I suspect the firmware inside the MCU (ATMEGA64A) got corrupted. Can someone in this forum by any chance provide... -
Actually this range had multiple problems but I fixed all the others already.
I am stuck finding a replacement infinity dual burner switch for a Kenmore C970-605121. The dual burner is stuck full on as soon as you turn the knob either side, either the difference of either only one or both burners running full tilt.
I tried cleaning it inside contacts, but that didn’t do anything.
I believe the dual burner switch reads a part number of: 318191021 which is hard to find. I came across a 318191026 part number but it has 2 pins on the row missing. Is there anything... -
Hello. I have Industrial Washing Machine PCB.
Customer Requested Relays Replacement.
I can't find WJ115F1 relays to buy. Looking for some help to identify possible alternative solutions.
Or any tips, on how to approach this situation.... -
Hi, I'm seeing one 9V relay having temperature 40C on its 9V (primary) side. Does that seem right? I switched 2 relays on that board and the temperature was the same (on the same position), so I'm sure it's not a faulty relay. I measured voltage on that relay and it was 9.5V DC, so that looks good. I don't see any other relay on that board having that kind of temperature and they have 9V on them too.
I thought maybe the transistor that is switching this relay keeps switching on/off, so I also checked for AC and there was almost none: 0.3V using mV range. No steady frequency was shown, but...
Comment