This operates the drum lamp on a tumble dryer when the door is opened.
The lamp does come on but is strobing at a constant rate.
The triac is Z3M and the uc is a MB95F582K.
Is it likely the uc is stuck in reset?
Resistors, diodes and cap C1 all appear ok.
KN1 connections as follows:
N.C
RST
DBG
Vcc
Gnd
Any ideas please.
The lamp does come on but is strobing at a constant rate.
The triac is Z3M and the uc is a MB95F582K.
Is it likely the uc is stuck in reset?
Resistors, diodes and cap C1 all appear ok.
KN1 connections as follows:
N.C
RST
DBG
Vcc
Gnd
Any ideas please.
Comment