a video taken what exactly is the problem ,signal from external decoder through HDMI and it's alternating 4 sec ok and 4 sec with double image problem
I hope it a bit clear
Thanks
the video show the screen display correct image first and back again so..
1- clean the LVDS cable between main boards and T-CON and seat it back in tight way.
2- take out the 2 ribbon cable between the T-CON and the panel .. inspect the silver / GOLD pins of them from both side with good loop . then clean them carefully and put them back one by one. each time u put back one side ribbon upload photo over here
I Cleaned the lvds cable from both sides and switch on again but with no hope, I also clean the the two flat cable from tcon to panel to LCD, attached will find two photos one with left flat cable removed and result in half pure white display, then I put back and i removed the right one and results is with half picture and with grey lines
yes but if you check post 3 the video attached the display is alternating from 4 sec ok to 4 sec to grey horizontal lines,so that why I not suspect with the tab bonding
Like I said, you can try the new T-CON if you want.
The Gate drives are on the side of the panel.
Tape off method does not cause money to try, it is up to you, do what ever you want.
yes the video show like cold soldering point .. also if you are sure went thru all tab bond and no change.. try with your HDMI signal while it play make pressure on the metal shield on the Main Boards.. and on several pints at the corners of the chassis to see if the issue changing time changed.. give time let the set warming up too.
This is 100% panel fault, don't waste money in other, need a tape masking method, unfortunately here is very hot and i don't know if i can help you for free.. tab rip off doesn't work i think because there are no tabs.. tellme if you have LG display.
This is 100% panel fault, don't waste money in other, need a tape masking method, unfortunately here is very hot and i don't know if i can help you for free.. tab rip off doesn't work i think because there are no tabs.. tellme if you have LG display.
who are you to asking fee for service over this forum and there allot other member more better than you give the advice and share their know how..
no need to list names over here... but one words enough to you shame on you.
Diah it is better that you stop it, you are not a moderator, i think was not a problem for the forum but i received a warn, so stop with your unuseful polemic, i don't shame on me stay calm, i think you was OK but i guess you are not so friendly, i don't think i am better than you, the difference is that i don't come here to make stupid comparison,, i'm not making a race, if you think you are better than me let demonstrate here solving this case without bothering me, i think you surely will solve this easy problem foryou like i think you have a good job that surely makes true every your desire. Don't make much moral. Don't make it so seroius, it was wonderful if everything was for free. It is more serious to offer a serious paid assistance than offer free advices that takes the wrong road like certain user are common to do here and appears in every discussion.
^ Isn't that a forum violation? Over 200 words and none had anything to do with fixing this double image issue, OP did you try turning down the backlights not brightness and see if display changes any?
Comment