Mac air a1466-820-00165-a-lock
Collapse
X
-
-
Macbook Air A1466 MB 820-00165-A
hi can someone help me with this locked bios? please ...Attached FilesComment
-
Re: Macbook Air A1466 MB 820-00165-A
this is your file clearedAttached FilesComment
-
A1466-820-00165-A-2.2-8GB Lock
A1466-820-00165-A-2.2-8GB Please clean password and clean me thanks in advanceAttached FilesComment
-
Re: A1466-820-00165-A-2.2-8GB Lock
try and report...Last edited by Claudiomfa; 07-10-2019, 10:39 AM.Comment
-
-
Re: Macbook air 13 a1466 bios lock
Dear sir can you help me to do it
https://www.badcaps.net/forum/showth...ighlight=a1466Comment
-
Re: Mac air a1466-820-00165-a-lock
hello friends
i have Macbook Air 1466 & EMC 3178 bios password kindly anyone can clean password for me thx
i am attaching my bios locked BINAttached FilesComment
-
Re: Mac air a1466-820-00165-a-lock
hereAttached FilesIm Back... sort of...Comment
-
Macair a1369 emc 2392(820-2838-a)
hi Ala Bro
can you clear the password from it ???
i m waiting thxComment
-
Re: Macbook Air A1466 MB 820-00165-A
please clean my a1466 biosAttached FilesComment
-
Re: Macbook Air A1466 MB 820-00165-A
pwd removed.Attached FilesComment
-
MAC AIR A1466 820-00165-a LOCKED
Hi freinds
macair locked
can helpAttached FilesComment
Related Topics
Collapse
-
by howardc64Problem
This is an LG edge LED lit LCD Display. The LEDs are on the bottom edge of the display. There are 2 bars (left and right) Each bar has many LEDs and a 6 pin connector. Each pin drive several LEDs thus is the highest current flow / heat junction. The weak lead free solder gradually fails with thermal expansion/contraction cycling and increases resistance. PSU will compensate up to a point, then when the current is too high, PSU just shut down the backlight causing a dark display. I have even seen one which the connector just fell off as solder points became completely detached....-
Channel: Troubleshooting Computer Displays
-
-
by acedogblastThis is a guide that I am writing for helping others to replace their MEC1503 EC chip if it breaks (or to get around an inconvenient prompt to the BIOS). This forum has been extremely helpful to me so I would like to contribute to help others. I will tell you right now that this task is very difficult to do. You MUST have experience and tools to do precision micro-soldering, BGA reballing, trace repair, and general laptop repair skills.
There are some specialty tools needed to do this task. The replacement MEC1503 chips can be acquired from Aliexpress. Do not buy the bare chips as... -
by DannyxGood day folks. I got a project on hand and would like some thoughts on whether it's possible to achieve, albeit impractical. You know me - I like to over-complicate stuff
The setup: I got a Paradox EVO192 alarm panel, a serial-to-ethernet adapter and an official PCS250 GSM communicator.
The task (TL/DR): connecting both the ethernet adapter AND the communicator to the single serial port of the Paradox panel. Connecting their TX/RX lines in parallel the data would get all messed up. At the very most, I THINK I could parallel the RX pins of the ethernet adapter... -
by longmt1990Hi, i have a Panasonic Cf-W5 with the bios password, I tried remove cmos but problem didnot solve.
I uploaded the picture after remove cmos battery, It look like this is a Phoenix bios. The bios dump file in the link i attached
Please help me remove bios password.
Thank you so much-
Channel: BIOS Requests ONLY!
-
-
by baletakHi,
had T490 with faulty bios chip. Bought chip out of ebay and soldered on. Laptop starts and works however serial numbers of laptop and motherboard do not match.
I have updated laptop model number.
1) I did not find the way to update laptop serial number - I have this one.
2) I dont know where to get my motherboard serial number and how to update it. Is it somewhere physically on the mainboard? How do I update it?
Hope to find someone to help me with this as I am hitting dead end at the moment.
Many thanks
Miro-
Channel: BIOS Requests ONLY!
-
- Loading...
- No more items.
Comment