Badcaps.net Forum
Go Back   Badcaps Forums > Troubleshooting Hardware & Devices and Electronics Theory > Troubleshooting Laptops, Tablets, and Mobile Devices
Register FAQ Calendar Search Today's Posts Mark Forums Read

 
Thread Tools Display Modes
Old 07-08-2020, 06:24 AM   #1
Lukosiukas
Member
 
Join Date: Jul 2018
City & State: Kaunas
My Country: Lithuania
I'm a: Knowledge Seeker
Posts: 44
Default Asus FX505DT

Hello, i need to identify a component. Computer do not turn on, this is getting extremely hot. No schematics or board-view available.
Markings on chip is :
W27
8
Attached Images
File Type: jpg 1.jpg (874.4 KB, 56 views)
File Type: jpg 2.jpg (313.9 KB, 66 views)
File Type: jpg 3.jpg (1.40 MB, 81 views)
Lukosiukas is offline   Reply With Quote
Old 07-28-2020, 06:51 AM   #2
Lukosiukas
Member
 
Join Date: Jul 2018
City & State: Kaunas
My Country: Lithuania
I'm a: Knowledge Seeker
Posts: 44
Default Re: Asus FX505DT

up, i dont want to pay 600euros for new motherboard
Lukosiukas is offline   Reply With Quote
Old 02-19-2021, 12:11 PM   #3
xweb
New Member
 
Join Date: Aug 2011
Posts: 7
Default Re: Asus FX505DT

same problem here... did you solve?
xweb is offline   Reply With Quote
Old 11-30-2021, 04:28 AM   #4
reformatt
Badcaps Veteran
 
Join Date: Feb 2020
City & State: Noosaville
My Country: Australia
Line Voltage: 240V 50hz
I'm a: Professional Tech
Posts: 329
Default Re: Asus FX505DT

I've just had one of these boards machines come through. The power adaptor immediately shuts down when connected.

Located the fault with voltage injection and thermal camera. The area in question by the OP is for CPU Vcore, and in my case was the AOE6932 dual FET to the left. Only one of the internal FET's had shorted, the other was ok. I usually find a dead CPU at the end of this scenario. The CPU measured a little over 1.2 ohms so I was not confident. But at least it wasn't a dead short. I didn't have a replacement at the time, so I took it off the board and saw what the other phase would do. Surprisingly I got 1V. Machine wouldn't fully start because of the missing phase, but there was hope.

So ordered it, and finally fitted the replacement AOE6932 today and machine is working fine. I have to assume the FET that shorted was the low side FET, not the high side as the CPU survived. I took the liberty to measure some volts on the coils for future reference. A little over 1 ohm seemed a little too low fpr Vcore, but there you go.
Attached Images
File Type: jpg FX550DT.jpg (574.3 KB, 22 views)
reformatt is offline   Reply With Quote
Old 12-01-2021, 01:19 PM   #5
caspian
Badcaps Veteran
 
Join Date: Oct 2015
City & State: Mainboard
My Country: Laptop
I'm a: Hobbyist Tech
Posts: 1,502
Default Re: Asus FX505DT

Thanks,
Is there any hot Mosfet now after the replacement?
How much hot is the CPU now?
caspian is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



Badcaps.net Technical Forums 2003 - 2022
Powered by vBulletin ®
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.
All times are GMT -6. The time now is 04:36 PM.
Did you find this forum helpful?