Announcement

Collapse
No announcement yet.

Lenovo ideapad 100-14IBD (NM-A681) not displaying

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Lenovo ideapad 100-14IBD (NM-A681) not displaying

    Hearty greetings to everyone.
    The above board has been giving me tough time.

    Please I need your help.

    The board powers on but no display, all voltages appear normal but CPU_DRAMRST# is 0.1V. The cooling fan started immediately but stops in less than 4 seconds, then starts again and stops finally in less than 3 seconds. The CPU gets warm then increases to very hot, since fan does not turn on to cool the CPU.

    Please help

    #2
    Re: Lenovo ideapad 100-14IBD (NM-A681) not displaying

    Flash known good bios first. Might be memory controller of SOC bad.

    Comment


      #3
      Re: Lenovo ideapad 100-14IBD (NM-A681) not displaying

      Originally posted by mcplslg123 View Post
      Flash known good bios first. Might be memory controller of SOC bad.
      Thank you.
      I've done that, but the problem persists.
      Now, the update is that the CPU does not warms up again, the CPU_CORE is shorted to the ground.

      The gate voltages of PQ39 and PQ40 are missing even with PL9 removed.

      I checked PU908, VCC is present but the pin 1 enable is absent.

      Please how can I proceed

      Comment


        #4
        Lenovo ideapad 100-14IBD (NM-A681) no display/ POST

        Please I need your help with the above motherboard. It was working then it froze, it was forced shut down but refuses to POST afterward. It powers on but no POST, no capslock led.

        The board powers on but no display, all voltages appear normal but CPU_DRAMRST# is 0.1V. The cooling fan started immediately but stops in less than 4 seconds, then starts again and stops finally in less than 3 seconds. The CPU gets warm then increases to very hot, since fan does not turn on to cool the CPU.

        I've flashed a certified BIOS, no difference.

        Now, the update is that the CPU does not warms up again, the CPU_CORE is shorted to the ground.

        The gate voltages of PQ39 and PQ40 are missing even with PL9 removed.

        I checked PU908, VCC is present but the pin 1 enable is absent.

        Please how can I proceed

        Comment


          #5
          Re: Lenovo ideapad 100-14IBD (NM-A681) not displaying

          What is the resistance on cpu coil(in ohms mode)?? I'm afraid but you might have shorted the SOC while measuring.

          Comment


            #6
            Re: Lenovo ideapad 100-14IBD (NM-A681) not displaying

            Originally posted by mcplslg123 View Post
            What is the resistance on cpu coil(in ohms mode)?? I'm afraid but you might have shorted the SOC while measuring.
            0 Ohms

            Comment


              #7
              Re: Lenovo ideapad 100-14IBD (NM-A681) not displaying

              Its "gone with the wind" baby. You need to replace the SOC or put in your scrap piles.

              Comment

              Working...
              X