Go Back   Badcaps Forums > Troubleshooting Hardware & Devices and Electronics Theory > Equipment Usage, Soldering, Techniques, and Reviews
Register FAQ Calendar Search Today's Posts Mark Forums Read

Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 12-03-2022, 11:32 PM   #1
Join Date: Nov 2022
City & State: jakarta
My Country: indonesia
I'm a: Knowledge Seeker
Posts: 20
Default Is it possible bridging tiny broken trace

When I assembled dreamcast I mistakenly fastened long bolt and It resulted in
cutting tiny trace.
This tiny trace(Total width of white coating is 5.5mm) is between R337,R343 and IC101 and it is covered with white coating in the below screenshot.

Firstly I tried to bridging tiny broken trace with my own eyes...But it is totally impossible..So a week ago, I ordered G1200 Digital Microscope and I magnified this tiny broken trace with it.

But It seems that It is really very tiny trace So I plan to order 0.1mm coper wire from aliexpress in order to bridging tiny broken trace.
And I have been using burnley solder paste for soldering But I think that Now I need a lot better solder paste or flux for this delicate soldering of bridging tiny broken trace.
Is it possible to bridging tiny broken trace like above screenshot and
If It is really possible to bridging tiny broken trace, What diameter size of coper wire and what type of solder paste or flux do I need?

Last edited by chth96; 12-03-2022 at 11:44 PM..
chth96 is offline   Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump Technical Forums 2003 - 2023
Powered by vBulletin ®
Copyright ©2000 - 2023, Jelsoft Enterprises Ltd.
All times are GMT -6. The time now is 12:55 PM.
Did you find this forum helpful?