Hello. Attempting to repair 2 different logic boards with i5 CPU + 8GB iMAC A1418 2k.
Each shows the first bottom LED on = power supply is good.
Power button is pressed -> LED 2 and then LED 3 each turn ON and then reset and recycle to only LED 1 (power supply) ON.
Checked against another logic board and found that inductor linked to FDMF6808N near CPU is @ 12.x Mohms.
Yet, on the board with the 'power cycling' is @ 2.x Mohms or lower.
Should FDMF6808N be replaced? Found some @ MobileSentrix. Weird that ONSEMI / Fairchild is not showing this component.
Is this an EOL component?
Welcome any suggestions for this repair. Now also have the DS-809SE tool as of yesterday. Should be able to read out the flash firmware for public posting.
Each shows the first bottom LED on = power supply is good.
Power button is pressed -> LED 2 and then LED 3 each turn ON and then reset and recycle to only LED 1 (power supply) ON.
Checked against another logic board and found that inductor linked to FDMF6808N near CPU is @ 12.x Mohms.
Yet, on the board with the 'power cycling' is @ 2.x Mohms or lower.
Should FDMF6808N be replaced? Found some @ MobileSentrix. Weird that ONSEMI / Fairchild is not showing this component.
Is this an EOL component?
Welcome any suggestions for this repair. Now also have the DS-809SE tool as of yesterday. Should be able to read out the flash firmware for public posting.
Comment