![]() |
|
|
Thread Tools | Display Modes |
![]() |
#1 |
Badcaps Veteran
Join Date: Jun 2018
City & State: Brampton
My Country: Canada
I'm a: Knowledge Seeker
Posts: 491
|
![]() Hi all, I am working on Hp 15-dy1731ms (Board # DA0P5DMB8C0 Rev: C ). Upone diagnostics I found one of the rect' diode (A2 1N) near the battery was burnt, I replaced with another good one. Did not turn on. I reprogram the BIOS chip & now the LED on the DC-in jack BLINKS 3 times when the switch is pressed & then shuts off completely. No shorted rail, all looks good. The battery charging chip used is BQ728H .... The voltages on this chip are below:
i) VCC Pin 19 19.4 V Ok (Pin 1-2-3 19V) ii) ACDET Pin 6 2.0 ( where as this should be 2.6 > ) iii) REGN/LDO/VVDP 5.9V Pin 16 ( seems to be ok) iv) ACOK 0.3 V Pin 5 (OPEN DRAIN OUTPUT) (Assuming pin should be high on BQ24728, about 3.2V) V) ACDRV Pin 4 24.2V (Ok) vi) ILIM Pin 10 1V Does anyone have the Schematic for this model to share or any tips will be greatly appreciated. Thanks |
![]() |
![]() |
Thread Tools | |
Display Modes | |
|
|