Badcaps.net Forum
Go Back   Badcaps Forums > Troubleshooting Hardware & Devices and Electronics Theory > Troubleshooting Power Supplies and Power Supply Design
Register FAQ Calendar Search Today's Posts Mark Forums Read

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 11-28-2021, 01:37 PM   #1
redwire
Badcaps Veteran
 
Join Date: Dec 2010
City & State: Alberta
My Country: Canada
Posts: 2,467
Default S-10-5 power supply schematic etc. 5V 2A

I got a 5V 2A power supply for some hobby projects from Aliexpress store YXD Wish for about $4. S-10-5 and the build quality good, solder blob under transformer and a solder balls on the PCB top so I cleaned that up.

Powered it up, get 5.0V but when connecting a load resistor it cratered. At 10R load which should be 0.5A, it dropped to 3.8V out and it went into hiccup mode below 5 ohms. About 1.5W output is all I can get.
I drew out the schematic and poked around with a scope. It's running slow at 31kHz and primary current pulses are measly 30mA. So I think the IC is fake and not working, it has no markings.
It appears to be a TX203H alternates are CR6203, RM6203, SDC603, SW2604, SL2128B. Commonly used in wall warts.
(The bottom rung version of this same S-10-5 using phenolic PCB, uses IC DK1203 Dongke Semi and no current-sense resistor, and cheapened other stuff.)

I asked for a refund and so far the vendor is quiet... I had another one ordered from a different Ali store but the floods took out rail and highways to the coast so it will be a while to get here and compare.

Don't forget website comparing pinouts of SMPS IC's. Good tool to reverse-engineer the IC used when there are no markings or it popped.
Attached Images
File Type: jpg S-10-5 power supply333.jpg (98.6 KB, 14 views)
File Type: jpg S-10-5 power supply top731.jpg (206.3 KB, 20 views)
File Type: jpg S-10-5 power supply bottom with solder blob 935.jpg (260.2 KB, 16 views)
File Type: jpg S-10-5 power supply 5V 2A schematic badcaps.JPG (152.9 KB, 19 views)
redwire is offline   Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



Badcaps.net Technical Forums © 2003 - 2022
Powered by vBulletin ®
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.
All times are GMT -6. The time now is 10:04 PM.
Did you find this forum helpful?