Announcement

Collapse
No announcement yet.

Lenovo ideapad 310-15IKB No Power

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Lenovo ideapad 310-15IKB No Power

    hello to all BadCaps

    I have Receive for repair
    Model: Lenovo ideapad 310-15IKB
    MOBO: NM-A981 Rev:1.0 (2016-06-16)

    Unit Status: No Power

    i check. have supply on rail. then i press power button. nothing happen no indicating power even light. but i try to hold the CPU & GPU heating Up.

    I check the 3.3Valw and 5Valw have and 1.8V Have

    then i check the supply on switch why 2v only. i think it is 3v?

    anyone can help me solve this or can you give me a Schematic .

    Thanks In Advance


    #2
    Re: Lenovo ideapad 310-15IKB No Power

    Up Up Up

    Comment


      #3
      Re: Lenovo ideapad 310-15IKB No Power

      same problem here, any help?

      Comment


        #4
        Re: Lenovo ideapad 310-15IKB No Power

        schematic is available:
        https://www.badcaps.net/forum/showthread.php?t=77863

        post measurements to have some information to go on...

        Comment


          #5
          Re: Lenovo ideapad 310-15IKB No Power

          Originally posted by juffe View Post
          same problem here, any help?
          Better make a new thread.
          Start by basic things : measurements ,resistance and impedance on all coils than post all that here

          Comment


            #6
            Re: Lenovo ideapad 310-15IKB No Power

            if its not turning on and all power rails are ok and all ALW voltage are present.. try to check the power switch 3.3V and 0v when on. try substituting known good memory module. place an external monitor and check. check the bios ic vcc.. rtc button battery. if ok. try to flash the bios with known good dump.. gud luck!
            Never stop LEARNING because life never stops TEACHING!

            Comment


              #7
              Re: Lenovo ideapad 310-15IKB No Power

              remove solder on JUMP_43X79 and measure voltage here.

              check also volts on pu401 pins
              could be ec need reprogramming ?
              Last edited by dellxps15; 08-16-2020, 03:17 AM.

              Comment

              Working...
              X