Has anyone used this product with a laser I saw this on YouTube and I going to give this a try once I get my laser up and running
Announcement
Collapse
No announcement yet.
Has anyone used this product Photosensitive Dry Film For PCB Circuit
Collapse
X
-
Has anyone used this product Photosensitive Dry Film For PCB Circuit
9 PC LCD Monitor
6 LCD Flat Screen TV
30 Desk Top Switching Power Supply
10 Battery Charger Switching Power Supply for Power Tool
6 18v Lithium Battery Power Boards for Tool Battery Packs
1 XBox 360 Switching Power Supply and M Board
25 Servo Drives 220/460 3 Phase
6 De-soldering Station Switching Power Supply 1 Power Supply
1 Dell Mother Board
15 Computer Power Supply
1 HP Printer Supply & Control Board * lighting finished it *
These two repairs where found with a ESR meter...> Temp at 50*F then at 90*F the ESR reading more than 10%
1 Over Head Crane Current Sensing Board ( VFD Failure Five Years Later )
2 Hem Saw Computer Stack Board
All of these had CAPs POOF
All of the mosfet that are taken out by bad capsTags: None
-
Re: Has anyone used this product Photosensitive Dry Film For PCB Circuit
https://www.ebay.com/itm/30cmx-100cm...53.m2749.l26489 PC LCD Monitor
6 LCD Flat Screen TV
30 Desk Top Switching Power Supply
10 Battery Charger Switching Power Supply for Power Tool
6 18v Lithium Battery Power Boards for Tool Battery Packs
1 XBox 360 Switching Power Supply and M Board
25 Servo Drives 220/460 3 Phase
6 De-soldering Station Switching Power Supply 1 Power Supply
1 Dell Mother Board
15 Computer Power Supply
1 HP Printer Supply & Control Board * lighting finished it *
These two repairs where found with a ESR meter...> Temp at 50*F then at 90*F the ESR reading more than 10%
1 Over Head Crane Current Sensing Board ( VFD Failure Five Years Later )
2 Hem Saw Computer Stack Board
All of these had CAPs POOF
All of the mosfet that are taken out by bad caps
-
Re: Has anyone used this product Photosensitive Dry Film For PCB Circuit
i wouldnt, that stuff used to be used in the days of masks and light-boxes.
it's difficult to get the board clean and smooth enough to apply.
it was replaced with pcb's with photo-sensitive mask already sprayed on them.
Comment
Comment