I have a thermistor (model SCK-054) I need to replace. It's not burnt but while pulling another component with that evil tan glue on it, I managed to rip a hole in the side of the thermistor (see photo). I expect powering it on in this state will likely result in flames.
Having never replaced one of these before, I am not sure which properties I need to take into account - can any parameters be higher or lower for a replacement?
The specifications of mine seem to be here: http://www.bentex.com.hk/catalog/the.../ntc/sck.shtml
Having never replaced one of these before, I am not sure which properties I need to take into account - can any parameters be higher or lower for a replacement?
The specifications of mine seem to be here: http://www.bentex.com.hk/catalog/the.../ntc/sck.shtml
Comment