Hi to all, I have a short to ground in this coil, I have a thermal camera, inyected 0.8V but nothing heats, it drawns between 0.6A and 1.5A.
First of all i have been searching for schematics of that card and searched all over the forum and internet about similar problems, I dont even know what rail it is, but I suppose it maybe the PEX rail?
I have removed the coil and the lower pad is the one shorted to ground.
Thanks a lot to all (and excuse my bad english)
(If someone could guide me where to get the correct boardview or schematis for this one... would gain a nice kiss)
First of all i have been searching for schematics of that card and searched all over the forum and internet about similar problems, I dont even know what rail it is, but I suppose it maybe the PEX rail?
I have removed the coil and the lower pad is the one shorted to ground.
Thanks a lot to all (and excuse my bad english)
(If someone could guide me where to get the correct boardview or schematis for this one... would gain a nice kiss)
Comment