Hi all, I have a Bush LED4012FHDCNTD with a backlight fault.
TV comes on as normal, backlights go out after a few mins, volume still present etc.
Stripped it down and tested strips and all LEDs illuminate, have illuminated strips individually for half hour and non go off.
Just wondering how I would connect tester to the plug to light the whole array? As there are 3 wires (pic attached)
TV comes on as normal, backlights go out after a few mins, volume still present etc.
Stripped it down and tested strips and all LEDs illuminate, have illuminated strips individually for half hour and non go off.
Just wondering how I would connect tester to the plug to light the whole array? As there are 3 wires (pic attached)
Comment