I have searched and not an electronics person so forgive me if I am about to sin and fixing to ask dumb questions.
In-Laws set they state it started to start up slower and slower till just black screen but they think still had sound.
I plugged it up and the Red status light is on till you push start and then it goes out and with the back off the only illumination I see is a red glow from the optical port. I checked the voltages on the connector that leads to the control buttons and have 5V where it states it should.
There is only two boards Ima call one the main big board and the other is the small or maybe Tcon board. I have no issue replacing one and see if that is it then the other my only concern is the LEDs' or something in the screen may be the issue ??
Any tips, prayers or advice is appreciated.
Thanks,
Yotaman
In-Laws set they state it started to start up slower and slower till just black screen but they think still had sound.
I plugged it up and the Red status light is on till you push start and then it goes out and with the back off the only illumination I see is a red glow from the optical port. I checked the voltages on the connector that leads to the control buttons and have 5V where it states it should.
There is only two boards Ima call one the main big board and the other is the small or maybe Tcon board. I have no issue replacing one and see if that is it then the other my only concern is the LEDs' or something in the screen may be the issue ??
Any tips, prayers or advice is appreciated.
Thanks,
Yotaman
Comment