DA0U82MB6D0 Bios & EC Files
Collapse
X
-
Hi I hope you need help file hp 15-n009se bios
Hi I hope you need help file hp 15-n009se bios
DA0U82MB6D0 REV.D
thank youMohammed MohanComment
-
Re: Hi I hope you need help file hp 15-n009se bios
Try form HP official web site....Comment
-
-
Re: Hi I hope you need help file hp 15-n009se bios
Unfortunately the file is lostMohammed MohanComment
-
Re: Hi I hope you need help file hp 15-n009se bios
here you go:Attached FilesComment
-
Re: Hi I hope you need help file hp 15-n009se bios
Thank you . I tried the file unfortunately the device did not workMohammed MohanComment
-
Re: Hi I hope you need help file hp 15-n009se bios
.Last edited by mohammed mohan; 02-05-2018, 02:12 AM.Mohammed MohanComment
-
Re: Hi I hope you need help file hp 15-n009se bios
But unfortunately lost the fileMohammed MohanComment
-
Re: Hi I hope you need help file hp 15-n009se bios
Dear friend, I dont think its a bios issue. Sourcebf has given you hp official dumps and polytek says his dump is tested ok. Check with signals like 3V/5V/15vALW, pch_RSMRST, SLP S3/SLP S4/5V-3V RUN ,1.5V RUN ETC.Comment
-
-
-
Re: HP 15-n015st - DA0U82MB6D0 Bios & EC Files
HP 15-n204ex - i5-NVidia
MB : DA0U82MB6D0
Board don't start . Until i clear Cmos ,remove main battery too.after that it works fine . Till i shut down . updated bios from HP site.
still same problem .
ThanksComment
Related Topics
Collapse
-
by Habble7The Samsung S49CG934SU monitor does not power on - no LED indicator activity and no response to power button. However, when 21V power is connected, it immediately draws 0.8A of current with no display output. The motherboard processor gets warm, and there is continuous reading activity from the W25Q128BV BIOS chip.
Suspected Cause:
I suspect the BIOS may have been corrupted during a power interruption while updating the firmware. The official website provides firmware updates, but they can only be installed via USB flash drive.
Troubleshooting Attempts:
...-
Channel: Troubleshooting Computer Displays
-
-
by DynaxSCHi, I have an MSI PRO B660M-G DDR4 board with damaged BIOS and i need a bios dump from a real board, along with MAC, UUID and Serial Number info (eg. a BIOS screenshot and pictures from the board stickers).
I need to reconstruct the bios on my board, based on another bios image form a real board - meaning a bios image containing MAC address, UUID and Serial number. A stock BIOS is not suffiecient, as it is impossible to discover where the MAC, UUID and SerialNumber are stored. Tried with a similar board, but there are too much differences, and the stock BIOS is missing a lot of...11-17-2023, 10:56 AM -
by grimacelordThis laptop is the same laptop I was working on in this thread and I wasn't sure if I should post a new topic or post in that thread because I already solved the issue that thread was discussing and this is a completely different issue although it is dealing with the same laptop. I decided to make a new thread since it's a new issue, but please move if I made a mistake.
Motherboard model number: DA0PAMB46A1 REV: A
Secondary motherboard model number: 0PAB
SKU: 685K4UA
Serial number is: 5CD3223BJP
Recently reflashed this laptop with latest BIOS and once...-
Channel: BIOS Requests ONLY!
-
-
by DynaxSCHi,
I need a BIOS dump for MSI Z590 PRO WIFI from a real physical board, along with MAC address and serial no.
It must be a dump from a physical board, as it contains personalized data eg. MAC Address, UUID, Serial no.
I have a board which has lost the BIOS contents, I have the MAC and serial to this board, and need to insert it into the another BIOS image. To do it, I need to have a real image from a real board, as the images from the MSI site are without this data. The only way to find where MAC/UUID/Serial is located in the BIOS is to have a bios...-
Channel: BIOS & Schematic Requests!
11-06-2022, 05:22 PM -
-
Hi everyone,
I'm trying to recover a Fujitsu Lifebook E5513 (most likely 2023 model) that was bricked during a BIOS update. The update was interrupted (probably due to power loss), and now the laptop is stuck in a boot loop showing "PBB rollback" / "SBB rollback" messages.
BIOS access (F2) and Boot Menu (F12) are no longer possible – the system instantly reboots after the rollback messages.
I extracted the official BIOS update package from Fujitsu (contains FJNB2FD.CAP, ~18.7 MB) and tried tools like UEFIExtract, but it seems to only contain...-
Channel: BIOS Requests ONLY!
-
- Loading...
- No more items.
Comment