Would these low ohm resistors make one of your output drivers (TTA5200) have low ohms between collecter and emitter..? It's a total PA Bluetooth board driving 15 inch driver It a NPN PNP output
It had blown outputs so I replaced but this low ohm reading is making me think they will blow again? I couldn't find anything else blown or short I think these low ohm emitter resistors are Messing with me.
1 is showing over 1meg emitter to collector the other looks short diode mode 0.069 and 96ohms
Is this normal?
It had blown outputs so I replaced but this low ohm reading is making me think they will blow again? I couldn't find anything else blown or short I think these low ohm emitter resistors are Messing with me.
1 is showing over 1meg emitter to collector the other looks short diode mode 0.069 and 96ohms
Is this normal?
Comment