thinkcentre m82 bios

[didouche1200]

i need dump bios+ec for thinkcentre m82 thinks

[SMDFlea]

Re: thinkcentre m82 bios

i need dump bios+ec for thinkcentre m82 thinks

Post your serial,machine type and bios backup .

[didouche1200]

Re: thinkcentre m82 bios

type model 2929
motherboard is7xm rev 1.0
buckup bios

[didouche1200]

Re: thinkcentre m82 bios

Any help

[SMDFlea]

Re: thinkcentre m82 bios

Any help

Here,try these .

ThinkCentre Edge 92, ThinkCentre M82, M92 and M92p, ThinkStation E31
Version 9SKT9CA

.

[didouche1200]

Re: thinkcentre m82 bios

not working with 2 beeps

[SMDFlea]

Re: thinkcentre m82 bios

not working with 2 beeps

clear the CMOS using the jumper.Put it on 1+2 start up and leave it for a minute,then press the start button for 10 seconds to shut down.Put the jumper back on 2+3 and start up. You can find where the clear CMOS jumper is in the hardware maintenance manual, page 76
https://cdn.badcaps-static.com/pdfs/...95171b42da.pdf

.

[didouche1200]

Re: thinkcentre m82 bios

Thanks for help the BIOS work 100%

[bios-scalper]

Re: thinkcentre m82 bios

How did you create these clean dumps? I tested both of your dumps and they work perfectly! Just curious how I can create or clean BIOS dumps.

[Last69]

Re: thinkcentre m82 bios

guys for you re info , dont upgrade lenovo bios if it s not necesary , i upgrade my m82 to latest bios , because why not and i cant boot from anything (ssd/hdd , usb storage , cd , other ways) , even i change everything on bios legacy and efi eather..leave the lenovo be or dont buy it , later!
P.S.: I will try you re bios posted above , mabye i will be lucky

[прямо]

Re: thinkcentre m82 bios

Here,try these .

ThinkCentre Edge 92, ThinkCentre M82, M92 and M92p, ThinkStation E31
Version 9SKT9CA

.

Am I correct to assume that I can just load the EC file into a hex editor and replace the MAC address which are located at file offset 0x1000 and 0x2000 with the MAC address from my board?

The same goes with replacing the serial number, product number and product name in the BIOS file?

I brought mine back to life with a BIOS + EC that I got from Lab-One Inside forum when I searched for IS7XM V1.00 BIOS but because of the MAC address is different, onboard ethernet doesn't work. Detected by Device Manager but can't load driver. If I had edited the MAC address, it'd probably work.